iWave Japan      Welcome to iWave Systems

iWave’s new improved Generic Qseven Carrier Board

iWave has launched its latest Generic Qseven Carrier Board which is compatible with Qseven latest R2.0 Specification. The board is also backward compatible with R1.2 Qseven specifications.

Any standard Qseven compliant module can be used with this Qseven Generic Carrier Board. Following different iWave’s Qseven CPU modules can be used with this Generic carrier board.

This Qseven Generic carrier board is  standard Nano ITX form factor (120x120mm) supporting an operating temperature of 0°C to 50°C operating temperature. The board accepts single 12V DC input and accommodates the major Qseven interfaces specific to the ARM based CPUs.

The Generic Qseven Carrier board supports the following features,

  • Debug UART console through USB Micro AB Connector
  • Up to 1Gbps Ethernet through RJ45 Magjack
  • Standard SD – 1 Port
  • Optional SDIO Taiyo Yuden Wi-Fi Module
  • USB 2.0 Host x 3 Ports
  • USB 2.0 OTG Port (Micro AB)
  • HDMI display Port
  • LVDS to RGB transmitter
  • 7” Capacitive Touch RGB Display – EDT
  • 4 Wire resistive touch controller
  • Optional 7” Resistive Touch RGB Display – Formike
  • LVDS display Ports – 2 Channels
  • GPIO Header
  • CAN ports with transceiver  – 2 Nos
  • SATA Port1  – 7 Pin Connector
  • SATA Port2 – 22 Pin Connector
  • Data UART – 1 Port
  • Optional GPS module
  • AC’97 Audio CODEC with 3.5mm Audio IN/Out Jack
  • Optional 4-Port PCIe switch
  • PCIe x 1 Connector to support PCIe
  • Half mini PCIe Port
  • On-board PCie based USB 3.0 controller
  • Optional USB 3.0 Host – 2 ports
  • SPI header
  • JTAG  Header
  • RTC Battery
  • I2C Sensors support -  Ambient Light Sensor, 3-Axis Accelerometer, Digital e-Compass & Altimeter/Barometer
  • Reset button
  • Power button

Besides the standard Qseven edge interfaces, the carrier board also supports two additional 80-pin expansion connectors to support the un-available features from in the Qseven edge. These expansion connectors are supported in all the iWave Qseven CPU modules.   

  • 8-bit CMOS Camera Port
  • MIPI CSI Port
  • NTSC/PAL encoder with TV IN Port
  • Keypad header
  • 120-Pin carrier expansion connector

 
Generic Qseven Carrier Board Block Diagram


Generic Qseven Carrier Board

Salma Quraishi- Member Technical - Hardware
iWave Systems Technologies