SDXC Host Controller

iW-SDXC Host controller is compatible with the SD Physical Layer specification V3.0. The core supports 32 bit AHB LITE Host interface working at SOC interface frequency.

SD/SDIO/MMC host Controller

iW-SD Controller interfaces SD / MMC / SDIO card to any processor with a generic interface. The interface towards the SD card is realized by the SD protocol implemented in the controller.

SDIO Slave Controller

iW-SDIO Slave controller acts as a bridge core of SDIO to UART. It also facilitates the design of SDIO cards and reduces the development time.

LPC-SPI Bridge

iW-LPC to SPI bridge provides an interface between LPC bus and SPI bus.The core consists of SPI master controller which facilitates to access SPI devices.

PCIe to ISA Bridge

The iW-PCIe to ISA Bridge consists of a single ISA bus controller & a Xilinx endpoint core for PCIe with PHY interface. The PCIe bridge is a 32 bit PCI express interface that fits into a single Spartan3 FPGA.

PCIe to UART Bridge

The iW-PCIe to UART Bridge consists of a single UART controller & a Xilinx endpoint core for PCIe with PHY interface. The PCIe to UART bridge is a 32 bit PCI express interface that fits into a single Spartan3 FPGA.

ATAPI Host Controller

iW- ATAPI Controller is designed to meet all the timing parameters of the ANSI standard. It supports ANSI ATA/ATAPI-6 standard compliance.

NAND Flash Controller

iW-Nand Flash Controller provides an easy interface to access Nand Flash Memory devices through simple register read/write.

PCI Controller

iW-PCI Controller provides an interface between the PCI bus and user interface. The core consists of PCI master block, PCI target block, Parity generator/Checker and etc.

CEATA controller

iW-CETA Controller is an interface between the processor and the CE-ATA Device. CE-ATA is the interface standard that was derived from MMC with the addition of ATA commands, small form factor, and power-conscious designs.

VME Interface

iW-VME Interface controller is a 16-bit slave controller. This can be configured through an external ARM processor.

Multibus Interface

iW-Multibus II Interface controller core is used to interface the external interface signals of the host processor with the Multibus interface.